User's Manual

Figure 98: Define drives for monitor type DISK
The line shown in the following figure is the opening tag for a drive definition.
Figure 99: Opening tag for a drive definition
You must define two parameters.
• Create the parameter "id" as a single upper case character that represents the drive name
to be monitored. For example, entering C as the "id" indicates that the C: drive is
monitored. This character is typically the drive letter you assign to the hard disk drive.
• Create the parameter "usage" as a numeric value that specifies a percentage of allowed
disk usage. For example, enter 70 to indicate that up to 70% of the hard disk can be used.
When less than 30% free capacity is available, you must notify users.
The window in the following figure shows a green bullet next to the C drive to indicate that the
required conditions are met. The window shows a red bullet next to the D drive to indicate that
for that drive, the conditions are not met. D drive is not ready or has reached the defined
usage.
Monitoring type DISK
DECT Messenger Installation and Commissioning — Book 1 March 2012 161