User's Manual

Figure 96: Example of monitoring section and subsections
The parameter interval, with a default value of 600, specifies the frequency at which the
monitoring process takes place. When a value of 600 is specified, a delay of 600 seconds
takes place between the last monitoring action and the next monitoring action. The eFR module
captures information about the configured items roughly every 10 minutes.
• The default value is 600 seconds
• The minimum value is 60 seconds. Every minute a verification cycle takes place. When
a value smaller than 60 is configured, the system adjusts it to 60 seconds
• The maximum value is 86400 seconds, so once a day a verification cycle takes place.
When a larger value than 86400 is configured, the system will adjust to 86400 seconds.
Note:
The processing cycle takes some time, for example PING to a large number of systems that
are not responding increases processing time. Since the interval effects the time between
ending the previous verification and starting a new verification, the exact frequency is
somewhat larger than the specified interval, depending on the processing time.
Monitoring
DECT Messenger Installation and Commissioning — Book 1 March 2012 159