User's Manual

Registry settings eTM 69

ATTENTION

If the environment names for eTM_HA are not defined with a name containing

the local IP address, rename the registry structure generated by eGRID or

eCONFIG, so that the IP address is available in the name.

The eTM structure can contain one or multiple environments. If you

launch the eTM_HA.exe without additional parameters, the program

analyzes the available environments of the registry, and prompt for an

initial environment at startup.

Figure 69 "Example of two environments" (page 69) shows an example,

with two environments defined. One environment is called Site 1 –

Environment 10.110.50.138, the other is called Site 1 – Environment

10.110050.138 (backup).

Figure 69

Example of two environments

If eTM_HA.exe is launched without additional parameters on a system with

local IP address 10.110.50.138, then a prompt appears as follows:

"C:\SOPHO Messenger@Net\Exe\eTM_HA.exe"

Figure 70

Selecting an environment when more than one is defined

Note: Because the objective of this module is to provide high

availability, Nortel recommends that you suppress this prompt. This can

be accomplished by adding a parameter on the command line of the

shortcut, specifying the initial environment to select. This is performed

by means of the optional keyword /Environment.

Create a shortcut for eTM_HA in the startup group specifying the initial

environment, as follows:

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010