User's Manual

413

Table: eWEB

eWEB parameters

eWEB_Address_str

This field specifies the IP address of the system where the Apache Web

Server is running.

You can obtain the address with the IPCONFIG command. The eWEB

module uses this address to obtain its site, area number, and the address

of the eKERNEL (based upon eWEB table) and to obtain the port number

at which eKERNEL listens (based upon eKERNEL_TCPCLIENT table).

This process is carried out in the PHP-scripts that run on the Apache Web

Server. As a result, the Web Server can use its own IP address to retrieve

the configuration data from the database. The values are needed in eWEB

to set up a proper socket connection to eKERNEL module, and to give

the user access to the correct site and area-related data. You can define

multiple addresses for the same eWEB module.

An authorized of an entry typically found in this field is as follows:

10.100.50.138

eWEB_Site_id_n

This field specifies the site number associated to the eWEB instance

obtained by the IP address of the Web Server. In most cases this value is

1, as defined in eKERNEL_SITE.

An authorized of an entry typically found in this field is as follows: 1

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010