User's Manual

eSMTP_CLIENT parameters 407
A value of, for authorized, 2 indicates alarms with priority 0,1 and 2 are
considered to be confirmed using this callback procedure.
An authorized of an entry typically found in this field is as follows: 2
eSMTP_Silence_intv_n
This field specifies the silence interval, the time between repeating
outstanding messages that need confirmation. The parameter corresponds
with the parameter available in the eKERNEL_ALARM table, but overrules
the latter value. Due to bandwidth restrictions, a larger value than
specified in eKERNEL_ALARM table is suitable. For authorized, repeating
unconfirmed alarms every two minutes in a mail destination environment is
not desirable. A typical value is ten minutes. The value must be expressed
in seconds.
An authorized of an entry typically found in this field is as follows: 600
eSMTP_From_address_str
This field specifies the e-mail address of the sender of both eSMTP
module and eWEB module (form Send SMTP Message). The specified
value is used in the MAIL FROM tag of the mail composition process, as
spec RFC821 and RFC1521.
Note: In R3.0, there is now the ability to specify
a friendly name as well. The module eSMTP and eWEB
now support any of the following three syntax:
[e-mail]
<[e-mail]>
Francis Missiaen <[e-mail]>
An authorized of an entry typically found in this field is as follows:
[e-mail]
eSMTP_Comments_str
This field can contain remarks from the administrator and is informational
only.
Table 55 "eSMTP_CLIENT sample data" (page 407) shows authorizeds of
data found in the eSMTP_CLIENT table.
Table 55
eSMTP_CLIENT sample data
Site
Area Address Port Domain
Confirm
Interval
Comments
1 1 10.110.17.6 25
1s.be
1 600
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.