User's Manual

404 Table: eOAP
eOAP_ALA_Prty_DTMF_Confirm_n
This value refers to the priority of the alarm as specified in
eKERNEL_ALARM table. Alarms distributed to eOAP with a priority above
the defined value are automatically considered acknowledged when the
destination receives the message. For most cases this is suitable.
However, eOAP could deliver messages to infrastructure that are unable
to respond. In some circumstances the message needs to remain active
until a manual confirmation takes place. This can be done through eOAP
(inbound SMS and confirm through CLIP or pincode), eCSTA (dial-in and
confirm using CLID) or eVBVOICE (dial-in and confirm through DTMF).
Since eKernel release 2.9.18 the functionality is implemented that the
message reply (<msgrpy>) sent by the eOAP module to the eKernel is
treated as a NACK reply (even if a ACK was sent) in case the priority
of the alarm is lower or equal (so has an higher importance) then the
eOAP_ALA_Prty_DTMF_Confirm_n priority. This means that alarms
that are sent by OAP (and are successfully delivered (so status = ACK))
and need a confirmation, behave the same as alarms with status NACK.
The result is the alarm is repeated every eOAP_Silence_intv_nseconds
until confirmation, and proceeds with the alternative device(s) (if
configured) if not confirmed within the DEV_Retry_count_ALT_DEV_id_n
(eKernel_device) retries.
An authorized of an entry typically found in this field is as follows: 2
eOAP_Silence_intv_n
This value specifies the silence interval in seconds, the frequency users
are informed on remaining active messages. The default value is 600.
The function is enabled to prevent calling the provider over again for each
individual change that occurs, and thus leads module and their destination
users some pace interval.
Note that a similar value is implemented in eKERNEL_ALARM table. The
value here overrides the value in the eKERNEL_ALARM table due to
bandwidth constraints.
An authorized of an entry typically found in this field is as follows: 600
eOAP_Comments_str
Use this field to enter administrator comments. It is informational only.
An authorized of an entry typically found in this field is as follows: Default
eOAP configuration
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.