User's Manual

ManualsBrandsAvaya ManualsHandsetsAvaya DECT Messenger with CS1000 Rls 7.0 - Book 2

401

402

403

404

405

406

407

408

409

410

402 Table: eOAI

eOAI_ALA_Prty_DTMF_Conﬁrm_n

This value refers to the priority of the alarm as specified in

eKERNEL_ALARM table. Alarms distributed to eOAI with a priority above

the defined value are automatically considered acknowledged when

the destination receives the message. For most cases this is suitable.

However, eOAI could deliver messages to infrastructure that are unable

to respond. In some circumstances the message needs to remain active

until a manual confirmation takes place. This can be done through eOAI

(inbound SMS and confirm through CLIP or pincode), eCSTA (dial-in and

confirm using CLID) or eVBVOICE (dial-in and confirm through DTMF).

Since eKernel release 2.9.18 the message reply (<msgrpy>) sent by the

eOAI module to the eKernel is treated as a NACK reply (even if a ACK

was sent) in case the priority of the alarm is lower or equal (so has an

higher importance) then the eOAI_ALA_Prty_DTMF_Confirm_n priority.

This means that alarms that are sent by eOAI (and are successfully

delivered (so status = ACK)) and need a confirmation behave the

same as alarms with status NACK. The result is the alarm is repeated

every eOAI_Silence_intv_nseconds until confirmation, and proceeds

with the alternative device(s) (if configured) if not confirmed within the

DEV_Retry_count_ALT_DEV_id_n (eKernel_device) retries.

An authorized of an entry typically found in this field is as follows: 2

eOAI_Silence_intv_n

This value specifies the silence interval in seconds; the frequency users

are informed on remaining active messages. The default value is 600.

The function is enabled to prevent calling the provider over again for each

individual change that occurs, and thus leads module and their destination

users some pace interval.

Note that a similar value is implemented in eKERNEL_ALARM table. The

value here overrides the value in the eKERNEL_ALARM table due to

bandwidth constraints.

An authorized of an entry typically found in this field is as follows: 600

eOAI_Comments_str

Use this field to enter administrator comments. It is informational only.

An authorized of an entry typically found in this field is as follows: Default

eOAI configuration

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010