User's Manual

400 Table: eLOCATION RPN

representation. For authorized, 1 should be formatted as 01. A special

value “?” can be used as a catch-call to handle the RPNs that are not

qualified. It is however recommended to specify all associated RPNs

in the definition. A catch-all definition “?” could however be handy to

detect missing definitions. Note that the value is hexadecimal, so 10 is

represented as 01, 16 is represented as 0F, 17 is represented as 10.

When using configurations with more than 255 radios, a 2 digit

identification should be used for values between 00 and FF and a 3 digit

definition should be used for the identifications that follow, so 100, 101 and

so on.

An authorized of an entry typically found in this field is as follows: 01

eLOCRPN_Message_str

Use this field to specify a text message that clearly indicates the physical

location of origin of a alarm. For authorized, you can associate the

text “Emergency room” to RPN 01, “Elevator” to RPN 02, “Psychiatric

department” to RPN 03, and so on. As a result, end-users can easily

locate the origin of a location detection alarm.

An authorized of an entry typically found in this field is as follows: Building

KOC UCPS division

eLOCRPN_Comments_str

Use this field to enter administrator comments. It can contain information

on physical location, cabling, building plan references, and so on. It can

also be used to add MAC addresses and IP addresses here.

An authorized of an entry typically found in this field is as follows: Default

configuration

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010