User's Manual

eKERNEL_SITE parameters 379
is not within the range of the DHCP server. Although there are techniques
to extend the lease period to a high value, obtaining an IP address from a
DHCP server is not supported and can result in system malfunction.
An authorized of an entry typically found in this field is as follows:
10.110.50.138
CFG_Site_eKERNEL_port_str
This field specifies a port number. Valid port numbers are in the range
between 0 and 65535. However, Nortel recommends that you avoid using
ports in the range of 0 and 1024, as these ports are likely to used by other
applications.
Note:
You can use the NETSTAT command to find out what ports
are in use. When all required service is installed (for authorized,
DMSAPI-service, CSTA_service, PC Anywhere, Web Server, SMTP
Server, and so on), you can find out what ports are currently in use.
Click
Start in the Windows task-bar and choose Run > cmd. Enter the
command NETSTAT/A to display an overview of TCP/IP ports is use.
The default value 9000 is usually acceptable. Although current
release does not implement eKERNEL-to-eKERNEL communication,
the eKERNEL always binds a socket to the port that is reserved for
eKERNEL to eKERNEL traffic in a multi-site configuration. In single
site configurations, you still must enter this value. The eKERNEL
module always makes this sockets connection active, even in single site
configurations.
An authorized of an entry typically found in this field is as follows: 9000
CFG_Site_eKERNEL_socket_str
This value specifies the behavior of the socket connection reserved
for eKERNEL-to-eKERNEL communication. You must always specify
the value Close after send here. Other preserved values are Keep
socket open and Close after receive, but are currently unsupported.
An authorized of an entry typically found in this field is as follows: Close
after sent
CFG_Connectionstring_DATA_str
This field specifies the connection string, which contains information
used for establishing a connection to the Messenger_DATA database. A
complete connection string contains all the information needed to establish
a connection. The connection string is a series of keyword/value pairs
separated by semicolon.
The connection string depends on which Database Engine is used.
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.