User's Manual

eKERNEL_INPGM parameters 369
The value must be set to the so-called COM-setting for the module eCAP
(RS-232 interfaces). The settings must be a supported combination of
baud-rate, parity, data-bits, and stop bits. The value must off-course match
the settings of the attached alarm system.
An authorized of an entry typically found in this field is as follows:
9600,N,8,1
INPGM_AutoCreateGRP_b
This value is an important value for relation to eKERNEL_GROUP and
eKERNEL_GROUP_MEMBER and eKERNEL_DEVICE.
This value defines whether alarms from the defined system must
automatically create a group in eKERNEL_GROUP table and a group
member in the eKERNEL_GROUP_MEMBER table and a device in
eKERNEL_DEVICE table. In most cases, the alarm system is unaware of
the range of groups and devices and need manual configuration. In this
case, the value is 0 (False).
In some cases, external parties can provide a valid DECT number in
alarm datastreams. This can be because the external parties are aware of
the infrastructure and number scheme of the DECT extension, or have
administrative tools available in the alarm systems that allow them to
adjust the alarm information according to the DECT Messenger number
scheme. This means the alarm systems are capable of sending alarms
containing correct destination numbers. Otherwise, they can provide a
valid DECT number in their alarm data streams.
When the alarm system provides valid device names in the alarm string,
you can choose to eliminate the need of defining the infrastructure over
again in the eKERNEL_GROUP, eKERNEL_GROUP_MEMBER and
eKERNEL_DEVICE tables.
ATTENTION
Carefully evaluate whether you trust the external parties in ALWAYS providing
valid information. If you do, set the value to 1 (True), indicating automatic
creation of groups, group members, and devices.
Nortel recommends using a value of 0 (False) unless you are fully aware
of the risks involved, for authorized, in receiving invalid devices.
If you activate this function, you must indicate in the fields INPGM_Default
_DEV_OUTPGM_str and INPGM_Default_DEV_OUTPGM_facility_str the
additional parameters that are needed for the auto—configuration process.
An authorized of an entry typically found in this field is as follows: 0
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.