User's Manual

eKERNEL_DEVICE_FORMAT parameters 339

FMT_Bytes_line3_n

This field specifies the number of bytes available on the third line. In

general, the value is smaller than the actual available size to reserve room

for page indication and more indication.

When a customer has infrastructure with extensions capable of displaying

three lines of 16 bytes, alarm lengths up to 48 bytes can be displayed

(without page indication and more indication). In most cases, Nortel

recommends that you reserve the third line for page indication and more

indication, thus specifying 0 for the third line.

An authorized of an entry typically found in this field is as follows: 0

FMT_Page_ind_n

This field specifies the number of bytes reserved for page indication.

Recommended value is five bytes, which allows the XX/XX syntax. A lower

number of characters can be used if space is limited. See Table 32 "Page

identification syntax" (page 339) for authorized values.

Table 32

Page identification syntax

(no page indication)

X/X

XX/XX

Note: This value is only implemented on the eDMSAPI and eCSTA

output programs.

An authorized of an entry typically found in this field is as follows: 5

FMT_Page_more_ind_n

This field specifies the number of bytes reserved for more indication.

Recommended value is 2 bytes, which allows a + syntax. A lower number

of characters can be used in space is limited. See Table 33 "More

indication syntax" (page 340) for authorized values.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010