User's Manual

ManualsBrandsAvaya ManualsHandsetsAvaya DECT Messenger with CS1000 Rls 7.0 - Book 2

321

322

323

324

325

326

327

328

329

330

eKERNEL_alarm parameters 321

On the other hand, when no changes occur, the outstanding messages are

repeated at the specified interval.

An authorized of an entry typically found in this field is as follows: 120

(denotes 2 minutes)

ALA_Scroll_state_str

This field specifies the state in which a device must be to receive

messages. Valid values are *CONNECT and *RINGING.

Scrolling starts at connect event when *CONNECT is specified, and starts

at ringing event when *RINGING is specified.

This parameter is however, due to architectural reasons, currently ignored

for most peripherals.

The value is used in eCSTA module release 2.8, where user-to-user

messaging is also supported in alerting phase. Most other technologies of

messaging are not call-oriented and do not have such requirements.

An authorized of an entry typically found in this field is as follows:

*CONNECT

ALA_Scroll_intv_n

This field specifies the number of seconds that is used as scroll interval,

when peripherals allow scrolling. This parameter is, due to architectural

reasons, ignored for most peripherals and is provided for backwards

compatibility issues.

An authorized of an entry typically found in this field is as follows: 3

ALA_Group_delivery_str

This value defines the degree of message delivery that is required on

delivery of a message to a group. Values can be *ALL or *ANY and is only

relevant if the field ALA_Remove_after_str is set to *SENT.

If the field ALA_Repeat_intv_n is set (value is greater than 0), than this

field is only relevant if ALA_Confirm_action_str is set to *YES.

If the field value is *ALL, each individual recipient handles their messages

on individual basis.

If the field value is *ANY, the message is only distributed to (at least) one

group member. When the first user confirms, the message is considered

delivered. This can result in removal of the message for all group

members. This can mean some group members do not see the message

at all.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010