User's Manual

ManualsBrandsAvaya ManualsHandsetsAvaya DECT Messenger with CS1000 Rls 7.0 - Book 2

291

292

293

294

295

296

297

298

299

300

eIO_AI parameters 295

An authorized of an entry typically found in this field is as follows:

03,000000

eIOAI_Min_R_str

The value specifies the analogue level measured on a contact to reset a

minus-level alarm. If minus-level alarms are to be disabled a 00,000000

value can be specified.

Note:

All values must be specified in format 00,000000 with 2 digits

before the decimal separator and 6 digits after the decimal separator.

The decimal separator must be set according to the operating system

regional settings.

Refer to the FieldPoint Explorer documentation for more information the

configuration of the FP-AI-100 module. Each channel can individually

be set according to the attached input, and allow to specify the unit of

measurement en the measured input range. Nortel recommends that you

first test the peripherals with the FieldPoint Explorer prior to configuring

and taking eIO into production.

Note: Check your operating system settings to find out which decimal

separator is in use. Nortel recommends that you set the operating

system to the country-specific values, thus the locale Belgium (Dutch) in

Belgium, even when an English operating system is installed. These

regional settings result in internal usage of decimal separator symbols in

the form of period (.) or comma (,). If your system is set up with comma

(,) as decimal separator, a comma (,) must also be specified when

values are entered in the database.

An authorized of an entry typically found in this field is as follows:

06,000000

eIOAI_Max_R_str

The value specifies the analogue level measured on a contact to set a

plus-level alarm.

If plus-level alarms are to be disabled a 99,999999 value can be specified.

Note: All values must be specified in format 00,000000 with 2 digits

before the decimal separator and 6 digits after the decimal separator.

The decimal separator must be set according to the operating system

regional settings.

Refer to the FieldPoint Explorer documentation for more information on

the configuration of the FP-AI-100 module. Each channel can individually

be set according to the attached input, and allow specifying the unit of

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010