User's Manual

294 Table: eIO_AI
Current implementation of eIO is limited to configurations of up to 8
modules attached to one FP-1000 controller module. Nortel recommends
starting the first module with number 01 and incrementing by one for the
other modules. Specify the leading 0 in the numbering (do not specify 1,
but specify instead 01).
An authorized of an entry typically found in this field is as follows: 01
eIOAI_Contact_str
This value refers to each individual contact, and is specified in the
FieldPoint Explorer. Valid values are in the range between 01 and 08
for the currently supported FP-AI-100. Note that contact numbers start
with 01 and are incremented by one. You must specify the leading 0 in
the numbering (do not specify 1, but specify instead 01). Note that some
peripherals of National Instruments include labels and documentations
where contacts start numbering at 0 up to 7, whereas eIO starts at 01 up
to 08.
An authorized of an entry typically found in this field is as follows: 01
eIOAI_Min_S_str
The value specifies the analogue level measured on a contact to set a
minus-level alarm. If minus-level alarms are to be disabled a 00,000000
value can be specified.
Note: All values must be specified in format 00,000000 with 2 digits
before the decimal separator and 6 digits after the decimal separator.
The decimal separator must be set according to the operating system
regional settings.
Refer to the FieldPoint Explorer documentation on how to configure the
FP-AI-100 module. Each channel can individually be set according to
the attached input, and allow specifying the unit of measurement en
the measured input range. Nortel recommends that you first test the
peripherals with the FieldPoint Explorer prior to configuring and taking eIO
into production.
Note: Check your operating system settings to find out which decimal
separator is in use. Nortel recommends that you set the operating
system to the country specific values, thus the locale Belgium (Dutch) in
Belgium, even when an English operating system is installed. These
regional settings result in internal usage of decimal separator symbols in
the form of period (.) or comma (,). If your system is set up with comma
(,) as decimal separator, a comma (,) must also be specified when
values are entered in the database.
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.