User's Manual

274 Table: eESPA

Table 15

Espa record: SOH1STX1US12345RS2USThe messageRS3US9RS4US3RS6U

S3ETXBCC (cont’d.)

RS Record separator

BCC Checksum

The incoming alarm/message, must be translated to a valid message

request and sent to the eKERNEL, as shown in Figure 205 "Example:

eESPA module acts as input program" (page 274).

Figure 205

Example: eESPA module acts as input program

If the specified data identifier is not present in the available datastream

record, than the field eESPA_Group_default_str must be used to define a

group in the message request.

If this eESPA module acts as an output program: In the current

release, the data identifiers for the espa records are fixed. Therefore,

when a message request is sent by the eKERNEL to the eESPA module,

the data in the <group> tag is put in data identifier 1 (call address).

In the following authorized, the data in the <group> tag from the message

request, must be translated to data identifier 1 (call address) in the espa

record.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010