User's Manual

eESPA parameters 273

If more than one address must be polled, the addresses must be

separated with a ^ sign. In this release, only a point to point link is

supported, so only one address can be specified.

An authorized of an entry typically found in this field is as follows: 2

eESPA_LocalAddress_n

This field specifies the address of the local espa interface.

An authorized of an entry typically found in this field is as follows: 1

eESPA_ExternalAddress_n

This field specifies the address of the remote station.

One eESPA interface is linked with one area, so is linked to only one

remote station. If more than one station can receive are sent espa alarms,

more areas must be configured in the configuration database.

An authorized of an entry typically found in this field is as follows: 2

eESPA_DataId_Group_str

Use this field to set the relationship between the DECT MessengerDevice

or Group and the data identifier of the espa record that specifies the

call address if eESPA acts as input program, so only relevant if eESPA

receives external data from the espa infrastructure.

If the eESPA module acts as input program: The eESPA module

receives espa records. Each espa record received must be translated to a

valid message request, and sent to the eKERNEL application.

The eESPA_DataId_Group_str field specifies the Data Identifier (normally

1) of the espa record that specifies the group. This group refers to the field

GRP_Descr_str of eKERNEL_GROUP table.

In the following authorized, data identifier 1 (call address) is defined as

eESPA_DataId_Group_str.

Table 15

Espa record: SOH1STX1US12345RS2USThe messageRS3US9RS4US3RS6U

S3ETXBCC

(SOH) Start of header

STX Start of text

ETX End of text

US Unit separator

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010