User's Manual

258 Table: eDMSAPI

An example of an entry typically found in this field is as follows: 3

eDMSAPI_GeneralTimeOut_n

This field specifies the Time, in seconds, the eDMSAPI program waits for

an event from the CSTA service. This value is by default 10 seconds, and

must be greater than 5.

When no event is received within this time, a negative acknowledge is sent

to the eKERNEL application or External clients for outbound calls.

An example of an entry typically found in this field is as follows: 10

eDMSAPI_Ack2TimeOut_n

Time in seconds the eDMSAPI program waits for an ACK message

request from the iSPBS, signaling that an URGENT message has been

read by the DECT user (outbound calls).

An example of an entry typically found in this field is as follows: 30

eDMSAPI_DataPathDelay_n

This keyword specifies the time in seconds to wait between receiving

a StopDataResult event form a device and before sending a new

StartDataPathRequest for the same device.

The default value is 2 seconds.

This parameter is implemented because the eDMSAPI module receives

Universal failure events (reason = INVALID_CALLING_DEVICE) when

sending a StartDataPathRequest directly after receiving a StopDataResult

for the same device.

An example of an entry typically found in this field is as follows: 2

eDMSAPI_Comments_str

This field contains remarks from the administrator and is informational

only.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010