User's Manual

ManualsBrandsAvaya ManualsHandsetsAvaya DECT Messenger with CS1000 Rls 7.0 - Book 2

251

252

253

254

255

256

257

258

259

260

eDMSAPI parameters 255

An example of an entry typically found in this field is as follows:

10.110.50.138

eDMSAPI_External_Port_str

This field specifies the port reserved for requests from the External clients.

This port can accept eDMSAPI_External_Seats_count_n simultaneously

requests.

The only valid format of the requests are:

SNDNMSG|ID|DNR|message<CR><LF>

SNDUMSG|ID|DNR|message<CR><LF>

An example of an entry typically found in this field is as follows: 2010

eDMSAPI_ALA_Prty_UMSG_n

This field specifies the priority an alarm message must have, to be handled

as an urgent message. The priority refers to the alarm priority as defined

in the eKERNEL_ALARM table. Alarms that do not meet the requirement

of being urgent are treated as normal messages. Refer to the DMS-API

related documentation for more information.

If, for example, 2 is specified, alarms with alarm priority of 1 and 2 are

handled as urgent messages, whereas alarms with priority of 3, 4, and

so on are handled as normal messages. Nortel recommends that you

carefully evaluate the consequences of changes to this field, for two

reasons:

• Emergency messages impact the DECT C4060 user (different tone,

user intervention required for acknowledge).

• Emergency messages impact throughput, because normal message

allocates a datapath a few seconds, while urgent messages can

allocate more than 30 seconds, depending on the timeout value

specified for user confirmation.

An example of an entry typically found in this field is as follows: 2

eDMSAPI_ALA_Prty_EMSG_n

This field specifies the required priority of an alarm message to be handled

as an emergency message. Introduced in R3.0, this field refers to the

support of C4060 handsets that allow emergency message levels. The

priority refers to the alarm priority as defined in the eKERNEL_ALARM

table. Alarms that do not meet the requirement of being urgent are

treated as urgent or normal message. Refer to the DMS-API related

documentation for more information.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010