User's Manual

128 Module - eWEB

The user can enter a message and the message type (normal or urgent)

and click Enter to transmit the message. The application waits for

message delivery or failure. In the case of urgent messages, this delay

can sometimes be quite long because the application waits for the user

to acknowledge receipt of the message by pressing OK on the DECT

handset.

Send SMTP Message

The Send SMTP Message window is shown in Figure 144 "Send SMTP

Message" (page 128).

Figure 144

Send SMTP Message

This function allows the user to send a message to a mail address

destination, by means of an SMTP connection between the Apache

Web Server and the SMTP server of the mail server. In this process,

no eKERNEL activity takes place, because the transaction is executed

directly.

The list of available addresses is limited to the devices that are defined in

eKERNEL_DEVICE table, and defined for the same site and area as the

eWEB application, and with output program eSMTP.

You can also make devices that are allocated to a remote area available

through the DEV_Ras_Area_b value in the eKERNEL_DEVICE table. An

example is shown in Figure 145 "Sending messages to remote addresses"

(page 129):

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010