User's Manual

Introduction 113

Figure 122

Ini settings - [Voicecard] (ACULAB specific settings)

[Voicecard] - (Dialogic specific settings)

Figure 123

Ini settings - [Voicecard] (Dialogic specific settings)

[Voicecard] - (Dialogic T1 specific settings)

T1 bit pattern settings are used to configure the T1 bit patterns for the A &

B bits for non-standard T1 configurations. The first digit is the value for ’A’

bit, the second is the value for ’B’ bit. The values can be "00", "01", "10" or

"11", where 00 means look for both A and B bits off, 01 means look for A

bit off, B bit on, and so on.

Valid values for t1hookflash_start and t1hookflash_end are as follows:

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 2

NN43120-301 02.01 4 June 2010