User's Manual

ManualsBrandsAvaya ManualsHandsetsAvaya DECT Messenger with CS1000 Rls 7.0 - Book 1

441

442

443

444

445

446

447

448

449

450

442 Module - eSMS

In addition a Siemens TC35i module, you need the following items.

•

a serial cable to connect the TC35i with the PC, included in TC35i

• a power unit and cable for the TC35i, included in TC35i

•

an antenna for the TC35i, included in TC35i

• a SIM card of mobile provider of choice with a PIN and a PUK code

Follow the steps in the next procedure to install the Siemens TC35i

module.

Procedure 76

Installing the Siemens TC35i module

Step Action

1 Install the SIM card in a regular mobile phone.

2 Power on the mobile phone.

3 Refer to the SIM card information and obtain the valid PIN and

PUK codes.

You usually need the pincode at startup.

4 Use the menu options of your regular mobile phone to disable

the PIN code check at power-up.

To verify that this step is complete, switch the regular mobile

phone off and on. The mobile phone no longer asks for a PIN

code and immediately becomes operational.

ATTENTION

Do not continue unless this step completed.

5 Ensure the location where you plan to install the Siemens TC35i

has sufficient coverage of your mobile provider.

The building environment can prevent good reception of a mobile

operator signal. When the reception is not optimal, consider

moving the antenna and box to a location with better reception.

Another solution to less than optimal reception on your mobile

phone is moving DECT Messenger to another place. You

can also consider a distributed setup running the eSMS and

SMS_service on a different PC.

6 Send and receive an SMS message manually to ensure operator

connectivity for SMS messaging runs properly.

7 Remove the SIM from your regular mobile phone, and insert it

in the Siemens TC35i module.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010