User's Manual

Architecture 439

The following figure shows an example of a message sent to the group

as defined in the Message parameter.

Figure 177

SOS message sent to group

The eKERNEL parses the data stream and performs the appropriate

replacements of the replacement values [calling number], [location] and

[location time].

Note: The "Site ID eLOCATION module" equals 1 and the "Area ID

eLOCATION module" equals 1 in the example shown in the previous

figure. The example indicates that the location request is resolved

by the eLOCATION module site 1 and area 1.

In DECT Messenger prior to release 2.9.10, the request is only

forwarded to eLOCATION with matching site and area (same

for eDMSAPI and eLOCATION). This means when eDMSAPI

resides on site 1 area 1, only the configuration records in

eLOCATION_INBOUND_RESULT with reference to site 1 and area

1 are used.

In DECT Messenger release 2.9.10 and in subsequent releases,

these requests are published to all available eLOCATION modules

residing on the same site, and the most recent location is used. In this

environment, the matching definitions for the available areas must also

be defined.

The possibility of using a "visual DNR" to a device in Messenger

(new field DEV_Visual_dnr_str in table eKERNEL_DEVICE for the

replacement value [calling number] is introduced in release 3.0. In

release 3.0 and subsequent releases, when the system configuration

configures a device with a visual DNR, this DNR is used to format

a message when it contains [Calling number]. The end-used is

confronted with the visual DNR instead of the device id.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010