User's Manual

eIO Modules 401

For each module, the URL is shown, and the module identifier. When

you hold the mouse pointer over the status area of a contact, detailed

information is shown. An example of the information provided is as follows:

Min (set: 02,000000 - reset: 08,000000)

Max (reset: 14,000000 - set: 20,000000)

The chart shown in Figure 142 "Analogue input ranges" (page

402) explains the behavior of these settings. The chart shows the voltage

levels between 0 and 24 V on the Y-axis, and the time between 12:00 and

12:45 on the X-axis. There are four different configuration values, which

are indicated in yellow. These values are retrieved from the eIO_AI table

and match the environment in FieldPoint Explorer.

On the chart, the analogue measured values are shown in black. The

green area is the idle zone, the red areas are alarm zones, and the grey

areas are transition zones.

• When the measured value reaches 20,00000 V, a MAX ALARM

condition is set. This is shown in the chart on 12:07.

• When the measured value drops to 14,00000 B, the MAX ALARM

condition is reset. This is shown in the chart on 12:27.

• When the measured value drops to 02,00000 B, the MIN ALARM

condition is reset. This is shown in the chart on 12:37.

•

When the measured value reaches 08,00000 V, a MIN ALARM

condition is set. This is shown in the chart on 12:45.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010