User's Manual

397

Module - eIO

Overview

The eIO module is a stand-alone application that communicates with

eKERNEL. The module is capable of controlling and measuring Distributed

I/O peripherals of National Instruments. eIO offers support for analogue

input, digital input and digital output.

See “Install PC - Step 3 - National Instruments” (page 111) for a detailed

explanation of installation and configurations issues of the modules, and

the supporting Measurement Studio components (FieldPoint Explorer and

OPC Server).

All these documents contain important information that is required to

understand and configure the eIO module. To avoid duplicate information,

the concepts are not repeated in this chapter.

Startup

You must start the eIO application by means of a shortcut that uses the

syntax described in Figure 137 "Parameters in the shortcut for eIO" (page

397).

Figure 137

Parameters in the shortcut for eIO

The following parameters are required:

• Site

Defines the site identifier and is used by eKERNEL to verify the

identifier with the eKERNEL_TCPCLIENT and eKERNEL_INPGM

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010