User's Manual

316 Module - eCAP

When HERSTEL occurs a general reset of all ARITECH alarms is issued

for *ALL groups and *ALL alarm descriptions.

Note: This protocol usually requires project-based consulting services

and customizing.

BEMAC

Valid manufacturer is BEMAC, valid model is DIANA 1 and DIANA 2.

Bemac is based upon installation Clinique St-Vincent Rocourt.

Figure 68

Sample Bemac protocol data

Bemac alarms contain three fields, a pager number, a message and a tone

code. Alarms are sent with group equal to the first parameter (for example,

866). The message is retrieved from the second parameter (for example,

LOC 101B). When the third parameter is 0 the message is reset. When

the message is RESET all messages for all groups are reset; in other

cases only the specific message for the specified group is reset. When

the third parameter is a value other than 0, the message is set. During set

the alarm description is BEMAC_x, where x is the specified tone code (for

example, tone code 3 sets message with alarm description BEMAC_3.

ELDAD

Valid manufacturer is ELDAD, valid model is specified through a special

syntax, for example, L:48-0:RC-1:SR-2:SS-3:SS-4SR. Note that the model

is built upon components having syntax A:BB and separated with a hyphen

(-).

• L:xx denotes that the length of an alpha-message is xx bytes. For

example, L:48 means that alpha-messages are 48 bytes long, L:24

denotes alpha-messages are 24 bytes long.

• 0:xx specifies behavior of tone code 0, 1:xx specified behavior of tone

code 1, 2:xx specifies behavior of tone code 2, and so on.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010