User's Manual

Editing eCONFIG.ini 205

IP address of the DECT Messenger system that runs eKERNEL must

be specified.

•

eKernel port: the default value 9000 is the port number that is typically

used in eKERNEL_SITE table as the administration port, which is used

in the sockets connection between eCONFIG and eKERNEL.

Note:

The language keyword pictured in Figure 22 "Missing parameters

prompt" (page 204) is no longer used, because the language of the user

is retrieved from the configuration automatically.

When the eCONFIG is installed on a local PC (that is, the same system

that runs the eKERNEL module of DECT Messenger), you can update the

shortcut with the missing parameters. To do so, edit the

target parameter

of the shortcut to match the following.

C:\SOPHO Messenger@Net eCONFIG\Exe\eConfig.exe

/eKernel address:*LOCAL /eKernel port:9000

When you make this change, eCONFIG no longer prompts for the

parameters at startup.

When the eCONFIG is installed on a distributed PC, Nortel strongly

recommends updating the shortcut with the IP address of the

eKERNEL. For example, if eKERNEL runs on a system with IP address

10.110.50.138, you must update the shortcut of all distributed PC systems

as follows:

C:\SOPHO Messenger@Net eCONFIG\Exe\eConfig.exe

/eKernel address:10.110.50.138 /eKernel port:9000

Editing eCONFIG.ini

Another important configuration setting is defined in the eCONFIG.INI file,

located in the path C:\SOPHO Messenger@Net eCONFIG\Exe, as shown

in Figure 23 "Accessing the eCONFIG.ini" (page 206).

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010