User's Manual

138 Install PC - Step 3 - National Instruments
3 Check firmware revision if it is not displayed in Step 2.
• If the firmware revision does not appear in the lower left
corner, as shown in the previous dialog box, enter revision
in the Name field.
The firmware revision appears in the upper-right corner as
shown in the following illustration.
•
Click Cancel to exit.
Note: Do not press Enter or click OK. Doing so renames the
module revision, resulting in undesired changes. Click Cancel
to exit from the Device Configuration dialog box.
--End--
Procedure 29
Determining which firmware you need
Step Action
1 Check to determine what firmware version you need.
Check Table 7 "Minimum firmware revision required for each
of the FieldPoint I/O modules" (page 139) to determine the
minimum firmware revision required for each of the FieldPoint
I/O modules. Use the table to compare the minimum firmware
requirement to your current firmware revisions that you found in
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 1
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.