User's Manual

122 Install PC - Step 3 - National Instruments

• Table 4 "Example 1c - FP-1000 module - Adjust contact configuration"

(page 128)

• Table 5 "Example 1d - FP-1000 module - Save configuration" (page

131)

Table 2

Example 1a - FP-1000 module - Connect hardware modules

Step

Action

1 Attach the modules and power supply.

• Attach the available modules (FP-AI-100, DP-DI-300, FP-DI-301, FP-DI-330,

FP-DO-401) to the FP-1000 controller.

• Attach the power supply to the FP-1000 module. If connected correctly, the

power and ready lights on all modules show a green LED.

2 Connect the serial cable.

•

Look for an available COM port on the PC, and determine the resource name.

This example uses COM01 port.

• Connect the DB-9 serial cable to the selected COM port.

Note: Refer to the FP-1000 documentation for more information on setting baud rate

and address on the module. In the example, the factory default settings are used.

Launch the FieldPoint Explorer.

Click Start and choose Programs > National Instruments > FieldPoint 3.0 >

FieldPoint Explorer.

4 Add a comm resource.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010