User's Manual

111

Install PC - Step 3 - National

Instruments

This chapter provides information on the following subjects:

•

“Installing the FieldPoint Explorer software” (page 111)

• “Installing DataSocket 4.0” (page 116)

•

“Launching FieldPoint Explorer” (page 121)

• “Installing latest firmware” (page 136)

•

“Using the eIO module” (page 144)

• “Accessing troubleshooting resources” (page 146)

This chapter describes the installation procedure of modules that are

related to the eIO component of Nortel DECT Messenger. You can skip

this chapter if you do not plan use the eIO module.

Note: This release of DECT Messenger provides the latest versions

available for FieldPoint Software Firmware and OPC Server. If you are

upgrading an existing configuration, Nortel recommends first removing

the previous versions.

Installing the FieldPoint Explorer software

The FieldPoint Explorer is a program provided by National Instruments,

which is required to detect and configure the connected distributed I/O

modules.

Procedure 26

National Instruments FieldPoint Software 3.0.2 (Build 177)

Step Action

1 Launch the Autorun.exe.

The software is located in the CD-ROM directory \03 - National

Instruments\03.02 – DataSocket 4.0\.

Double-click the Autorun.exe file to start installing.

Nortel Communication Server 1000

DECT Messenger Installation and Commissioning — Book 1

NN43120-301 02.01 4 June 2010