User's Manual

140 DECT Messenger Customer Engineer Manual
After processing the e-mail message, the eSMTP_Server puts the
message in the directory C:\inetpub\mailroot\drop\processed. If the
message cannot be properly processed, eSMTP_Server does not
put the message in the processed directory, but in the directory
C:\inetpub\mailroot\drop\error.
Note: You do not need to create users in the IIS. IIS is used for
incoming SMTP only. On incoming e-mail, no authentication check is
done. A message to any user (the address part preceding the @ in the
e-mail address) is accepted. However, the domain name (part after
the @) is checked by IIS.
Figure 44
Example of e-mail message
The following fields in the message are processed:
• x-sender: [e-mail]
The part that follows after x-sender: is the originator of the message;
a confirmation message is sent to this address. If you have an e-mail
server program other than IIS, there is no x-sender: field. Then the
eSMTP_Server uses the field: From: sue1 <[e-mail]>
instead.
• x-receiver: [e-mail]
The part that follows after x-receiver: is used to determine to which
DECT Messenger group the message must be sent. (A group contains
devices which are assigned as members). The conversion is made
in the eKERNEL_Group and eKERNEL_Member tables. If you do
not have IIS but another e-mail server program instead, there is
Nortel Communication Server 1000
DECT Messenger Fundamentals
NN43120-120 02.01
11 May 2009
Copyright © 2003-2009 Nortel Networks
.