User's Manual

Connecting National Instruments modules 125

7 Right-click the device you wish to edit.

• Right-click a device.

• In the pop-up menu, select Edit this Device...

8 Set channel configuration values.

Click Configure channels.

In the Channel configuration window that is displayed, enable the

lines that you use, and select the correct settings (this depends

on what you have connected to the channels).

Click Apply, and then OK.

9 Edit the remaining devices.

• Click OK to close the Device configuration window.

• Repeat steps 7 and 8 for each device.

10 Start Monitoring channels.

Your devices are now set up. If you right-click an individual

channel, and select Edit this item... from the pop-up menu,

information about the channel is displayed, including channel

connections.

Now you can start monitoring the channels. Click the Start

Monitoring menu from the menu I/O or click the associated

button in the tool bar. Now line monitoring is started. If you

select a device in the left pane, the channel status is displayed

in the right pane. If the input on that device module changes, the

display is updated to show the changed channel status.

11 Close the FieldPoint Explorer.

Nortel Communication Server 1000

DECT Messenger Fundamentals

NN43120-120 02.01

11 May 2009