User's Manual

attempt, the application clears the message for this device and send the message to the
alternative device, if defined.
Note:
In this second case (value=1), the switch to the alternative device is immediate (that
is, there is no silence interval between the two calls). Therefore, you must ensure that
there are no loop conditions defined in the list of alternative devices.
A value of 2 indicates that the alternative device is contacted after the second attempt.
• IO Register
This parameter is only applicable for devices that are assigned to output program
eDMSAPI.
All devices with this value set to True are monitored by the eDMSAPI to see if an E2
message is sent. After a device sends an E2 message, the message always goes to
DECT Messenger directly (and not to the destination number). Messages sent to DECT
Messenger are processed by DECT Messenger in the same way that messages from
other input devices are processed. There must be a correct specification in the eDMSAPI
inbound configuration that points to a group and an alarm. The message is sent to the
group members in the group that is assigned to the inbound configuration in the
eDMSAPI.
• Alternative devices
Use this parameter to assign one or more alternative devices to a device. After you click
this item, a panel at the right side of the window displays the list of possible alternative
devices. Select New from the menu to add an alternative device. Select Edit to make
changes in the list of alternative devices already assigned to this device.
• Remote access site
The Remote access site parameter is only applicable when you have more than one
site, and you are using the web interface. A web server (eWEB) and a device are each
assigned to only one site; if both are assigned to the same site, you can see the device
from the web interface. Devices assigned to sites other than that to which the web server
is assigned are only visible if the Remote access site parameter is set to True.
• Remote access area
The Remote access area parameter is only applicable when you have more than one
area, and you are using the web interface. A web server (eWEB) and a device are each
assigned to only one area; if both are assigned to the same area, you can see the device
from the web interface. Devices assigned to areas other than that to which the web server
is assigned are only visible if the Remote access area parameter is set to True.
• Comments
This field is informational only, and can contain remarks from the administrator.
Avaya DECT Messenger Administrator Guide
30 DECT Messenger Fundamentals March 2012
Comments? [e-mail]