User's Manual

This tag specifies from which module the message comes. In Figure 54: IO Module log
file on page 157, the message comes from the second module.
• <contact>01</contact>
This tag indicates the contact on the IO module.
• <sts>1</sts>
This tag indicates the contact status. 1 means that the contact was activated.
In the file shown in
Figure 54: IO Module log file on page 157, the following messages have
been exchanged between the eIO module and the eKERNEL for each line:
1. 18/11/2002 11:53:04 - O:TCP:<xml><msgrqs>type>DI</ type><module>02</
module><contact>01</contact><sts>1</sts></msgrqs></xml>
An outgoing message request from eIO to eKERNEL. Contact 01 on module 02 has
been activated. (The input module is type DI.)
2. 18/11/2002 11:53:05 - O:TCP:<xml><msgrqs><type>DI</ type><module>02</
module><contact>01</contact><sts>0</sts></msgrqs></xml>
An outgoing message request from eIO to eKERNEL. Contact 01 on module 02 has
been de-activated. (The input module is type DI.)
3. 18/11/2002 11:53:06 - I:TCP<:xml><msgrqs><id>00431</ id><site>1</
site>module>03</module><contact>01</ contact><sts>1</sts><reset_delay>3</
reset_delay></msgrqs></xml>
An incoming message request in eIO from eKERNEL. Command to activate contact
01 on module 03 for a time period of 3 seconds. (Message identifier 00431.)
4. 18/11/2002 11:53:06 - O:TCP:<xml><msgrpy><id>00431</ id><module>03</
module><contact>01</contact><sts>ACK</sts></msgrpy></xml>
An outgoing message reply from eIO to eKERNEL as an acknowledge (ACK) on
message request in line 3. (Message identifier 00431.)
5. 18/11/2002 11:53:06 - I:TCP:<xml><msgrqs><module>03</
module><contact>01</contact><sts>0</sts><reset_delay>0</ reset_delay></
msgrqs></xml>
An incoming message in eIO from eKERNEL to reset the contact 01 in module
03.
Module Window
Each module runs as an application in the Windows environment, and can be displayed as an
open window, or minimized on the Windows Task bar. The module window provides online
information about settings, commands/messages/communication. This information is very
useful for debugging. The eIO module is shown for the purposes of demonstration; other
DECT Messenger Customer Engineer Manual
158 DECT Messenger Fundamentals March 2012
Comments? infodev@avaya.com