User's Manual

eLOCATION Module in eCONFIG
The eLOCATION module is configured through eCONFIG.
Figure 34: eLOCATION module
A number of parameters, for example Site, Area, and so on, are the same for all modules and
therefore, are not explained here. However, the following parameters are new in the
eLOCATION module and require some explanation:
• Location Agent Address
This is the IP address of the DAP Controller (DCC) to which the IP connection is made.
• Location Agent Port
This is the port number on the DAP Controller (DCC) to which the IP connection is made.
The port number must be 28008 for a SIP DECT system.
• General Timeout
Protocol guarding. Always is 10 seconds.
• Retry Count
Retry counter for retrieving information from the DAP Controller. Default = 5.
• Retry Interval
Retry Interval time between retries. Default = 10 seconds.
• Polling Interval
Polling interval is the interval time between poling message to the DCC to check if the
connection is still alive. Default = 60 seconds.
eLOCATION
DECT Messenger Fundamentals March 2012 109