Release Notes

Known issues 13
Release Notes for the Business Policy Switch 2000 Software Version 2.0
• When you are working with QoS configurations and you delete a filter, that
filter will continue to operate until you reset the BPS 2000. (CR Q00071760)
• When working in a mixed stack with BayStack 450 v.4.0/4.1 and BPS 2000,
only the BPS 2000 displays the IP address of the stack.
(CR Q00079143)
• When using the CLI and entering the IP address and mask in the form of
A.B.C.D/<0-32>, you can also enter the values in the form of
A.B.C.D/E.F.G.H.
• Occasionally when you have disabled MAC address-based security, the ports
will still register as an intrusion. (CR Q00092007, Q00091998)
The workaround is to reset the stack.
• The port speed and duplex you set using the ASCII configuration file may
show incorrectly in the console display that shows port speed and duplex. The
actual speed and duplex will be what you set with the configuration file, but
the console display for these parameters may be incorrect. (CR Q00083014)
The workaround is to use the CLI.
• When you are using DM to display the spanning tree group memberships, the
port members may not display correctly. (CR Q00093350) Use the console
interface (CI) menus, the CLI, or the Web-based management system to
double-check the spanning tree group memberships.
• EAP configuration changes made at one console or using DM may not
automatically display on other consoles. (CR Q00044484, CR Q00045315)
The workaround is refresh the console and the correct data displays.
• If you rapidly add and delete VLANs (more than 1 per second) using DM,
some of the VLANs may not be configured.
The workaround is allow a few seconds to elapse between adding and deleting
ports and VLANs if you are using DM.
• The ASCII configuration file does not support multiple spanning tree
operations. (CR Q00088185)
Use the CI menus, CLI, the Web-based management system, or DM to
configure multiple spanning tree groups.