Release Notes

10 Resolved issues
210676-F
• Improved QoS Wizard Web configuration pages
• QoS Quick Config Web configuration pages
• QoS filtering of multiple VLANs per Layer 2 filter
• Configurable VID for tagged STP BPDUs
• IP address for each switch in a stack
• MAC destination address (DA) filtering
• Port naming
• QoS policy enable or disable
• Enhanced Web QoS error reporting
Resolved issues
The following issues were resolved in version 2.0:
• The
show log and clear log CLI commands now function correctly. (CR
Q00047028)
• The Web-based management system now correctly displays all configured
VLANs. (CR Q00101635)
• IGMP Proxy now works correctly on tagged ports with multiple VLANs in
multiple spanning tree groups. (CR Q00084861)
• It no longer takes a long time for the ASCII config file with extensive
configurations to complete. (CR Q00091334)
• The flash synchronization was every 60 seconds. This synchronization now
occurs very 2 minutes and 30 seconds.
• The setting of Learn by Ports in the MAC address-based security no longer
changes to disabled after you reset the switch or stack. (CR Q00147573,
Q00043550)
• You can now ping the switch if the MAC address-based learning security
setting for the management port is set to Enabled. (CR Q0008448)
• The BPS 2000 switch no longer caches RADIUS responses (so that
connections were authorized even when server is down). (CR Q00043170)
The stack stability was greatly enhanced in version 1.1.1.