User's Manual

8
Mount the speaker assembly to the bottom surface of the ceiling tile. Secure with four mounting screws and J-nuts as
illustrated.
Mounting Round Speaker Assembly
Note: If a backbox has been installed,
speaker assemblies still mount as shown.
9
Use a screwdriver to turn the attenuator (located in the center of the speaker grille) to the fully clockwise position.
Make a test page and adjust the attenuator and tap settings as follows:
a) If page is too loud, turn the attenuator counterclockwise until desired level is attained.
b) If page is not loud enough, move the signal wire to the next higher tap setting and retest. Continue until the
appropriate tap setting is reached and use the attenuator to make fine adjustments.
Note:
Final testing and adjustments should always be made at normal building sound levels.
Page 4 of 4