User's Manual

Avaya Branch Gateway Manager 10.0 Page 852
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Type
Party Device
Party Name
Line
T<9000+line number>
Line <line number>.<channel if applicable>
Other
V<8000+device number>
U<device class> <device number>.<device
channel>
Unknown/Tone
V8000
U1 0.0
13.Party1Name
The name of the device – for an extension or agent, this is the user name.
14.Party2Device
The other party for the SMDR record of this call segment. See Party1Device above.
15.Party2Name
The other party for the SMDR record of this call segment. See Party1Name above.
16.Hold Time
The amount of time in seconds the call has been held during this call segment.
17.Park Time
The amount of time in seconds the call has been parked during this call segment.
18.AuthValid
This field is used for authorization codes. This field shows 1 for valid authorization or 0 for invalid authorization.
19.AuthCode
This field shows either the authorization code used or n/a if no authorization code was used.
20.User Charged
This and the following fields are used for ISDN Advice of Charge (AoC) . The user to which the call charge has been
assigned. This is not necessarily the user involved in the call.
21.Call Charge
The total call charge calculated using the line cost per unit and user markup.
22.Currency
The currency. This is a system wide setting set in the system configuration.
23.Amount at Last User Change
The current AoC amount at user change.
24.Call Units
The total call units.
25.Units at Last User Change
The current AoC units at user change.
26.Cost per Unit
This value is set in the system configuration against each line on which Advice of Charge signalling is set. The values
are 1/10,000th of a currency unit. For example if the call cost per unit is £1.07, a value of 10700 should be set on the
line.
27.Mark Up
Indicates the mark up value set in the system configuration for the user to which the call is being charged. The field is
in units of 1/100th, for example an entry of 100 is a markup factor of 1.
28.External Targeting Cause
This field indicates who or what caused the external call and a reason code. For example U FU indicates that the
external call was caused by the Forward Unconditional setting of a User.
Targeted by
Reason Code
HG
Hunt Group.
fb
Forward on Busy.
U
User.
fu
Forward unconditional.
LINE
Line.
fnr
Forward on No Response.
AA
Auto Attendant.
fdnd
Forward on DND.
ICR
Incoming Call Route.
CfP
Conference proposal (consultation) call.
RAS
Remote Access Service.
Cfd
Conferenced.
?
Other.
MT
Mobile Twinning.
TW
Teleworker.
XfP
Transfer proposal (consultation) call.
Xfd
Transferred call.
29.External Targeter Id
The associated name of the targeter indicated in the External Targeting Cause field. For hunt groups and users this will
be their name in the system configuration. For an Incoming Call Route this will be the Tag if set, otherwise ICR.
715