User's Manual

Avaya Branch Gateway Manager 10.0 Page 789
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Data Routing: Examples
3.Create an IP Route
By creating an IP route with blank IP address details, it becomes the default route for outgoing IP traffic.
1.Select IP Route to display existing routes.
2.Click on and select IP Route.
3.Leave the IP Address and IP Mask fields blank.
4.In the Destination field, select the WAN service.
5.Leave the Metric at default value of 1.
6.Click OK.
4.Configure the Line Channels
This stage of the process differs according to the type of trunk being used.
5.T1 Trunk
Use the following for a T1 trunk.
1.Click Line to display the existing lines.
2.Double-click on the line previously entered in the WAN Port settings.
3.Check that the Channel Allocation order matches that required by the ISP. Cisco routers typically use 1|24.
4.Select the channels to be used in the WAN PPP link and change their Channel Type to “Clear Channel 64k”.
5.Click OK.
6.Click OK again.
7.Send the configuration to the system and reboot.
6.T1 PRI Trunk
Use the following for a T1 PRI trunk.
1.Click on Line to display the list of existing lines.
2.Double-click on the line previously entered in the WAN Port settings.
3.Check that the Channel Allocation order matches that required by the ISP. Cisco routers typically use 1|23.
4.Select the channels to be used in the WAN PPP link and change their Admin to “Out of Service”.
5.Click OK.
6.Click OK again.
7.Send the configuration to the system and reboot.