User's Manual

Avaya Branch Gateway Manager 10.0 Page 76
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
3.5.1 General Settings
These settings are displayed when General is selected in the navigation pane.
· Security Administrator
The security administrator is a special service user who does not belong to any Rights Groups. The security
administrator is able to access the system's security settings but cannot access its configuration settings. By default
they are the only service user able to access to the security settings.
· Unique Security Administrator: Default = Off
When selected, only the Security Administrator is able to access the system's security settings. When this is
selected, the security options for Rights Groups are disabled. When not selected, the ability to access security
settings can also be assigned to Rights Groups.
· Name: Default = 'security'. Range = 6 to 31 characters.
The name for the Security Administrator.
· Password: Default = 'securitypwd'. Range = 6 to 31 characters.
The password for the Security Administrator. In order to change the Security Administrator password, the current
password must be known.
· Minimum Password Complexity: Default = Low.
The password complexity requirements for the Security Administrator. This setting is active for attempted password
changes on both Security Manager and the system.
· Low
Any password characters may be used without constraint.
· Medium
The password characters used must include characters from at least 2 of the 'code point sets' listed below. For
example a mix of lower case and upper case. In addition, there should not be any adjacent repeated characters of
any type.
1.Lower case alphabetic characters.
2.Upper case alphabetical character.
3.Numeric characters.
4.Non-alphanumeric characters, for example # or *.