User's Manual

Avaya Branch Gateway Manager 10.0 Page 697
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Apperance Button Operation: Programming Appearance Buttons
8.7.3 Line Appearance ID Numbers
Line appearances are supported for analog, E1 PRI, T1, T1 PRI, and BRI PSTN trunks. They are not supported for E1R2,
QSIG and IP trunks.
Note that setting and changing line settings including line appearance ID numbers requires the system to be rebooted.
Automatic Renumbering
1. Select Tools | Line Renumber.
2. Select the starting number required for line numbering and click OK.
3. All lines that support Line Appearance ID will be numbered in sequence.
Manual Renumbering
1. Start Branch Gateway Manager and load the current configuration from the system.
2. Select Line.
3. Select the line required. The tab through which line appearance ID numbers are set will vary depending on the
type of line. A couple of examples are shown below.
· Analog Line
On the Line Settings tab select Line Appearance ID and enter the ID required.
· Basic/Primary Rate Trunks
On the Channels tab select the individual channel and click Edit. Select Line Appearance ID and enter the
required ID, then click OK. Repeat for all the channels required.
4. Click OK and repeat for any other lines.