User's Manual

Avaya Branch Gateway Manager 10.0 Page 688
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
8.6.9 Joining Other Calls (Bridging)
Appearance buttons can be used to "join" existing calls and create a conference call. A user can join calls that are shown
on their phone as 'in use elsewhere'.
· This feature is often referred to as 'bridging into a call'. However this causes confusion with Bridged appearance
buttons and so the term should be avoided.
The ability to join calls is controlled by the following feature which can be set for each user:
· Cannot be Intruded: Default = On
If this option is set on for the user who has been in the call the longest, no other user can join the call. If that user
leaves the call, the status is taken from the next internal user who has been in the call the longest. The exceptions
are:
· Voicemail calls are treated as Cannot be Intruded at all times.
· When an external call is routed off switch by a user who then leaves the call, the Cannot be Intruded status
used is that of the user who forwarded the call off switch.
· Any call that does not involve an internal user at any stage is treated as Cannot be Intruded on. For example:
· When an external call is routed off switch automatically using a short code in the incoming call route.
· VoIP calls from a device not registered on the system.
· The Can Intrude setting is not used for joining calls using appearance buttons.
The following also apply:
· Inaccessible
In addition to the use of the Cannot be Intruded setting above, a call is inaccessible if:
· The call is still being dialed, ringing or routed.
· It is a ringback call, for example a call timing out from hold or park.
· If all the internal parties, if two or more, involved in the call have placed it on hold.
· Conferencing Resources
The ability to bridge depends on the available conferencing resource of the system. Those resources are limited
and will vary with the number of existing parties in bridged calls and conferences.
· Conference Tone
When a call is joined, all parties in the call hear the system conferencing tones. By default this is a single tone
when a party joins the call and a double-tone when a party leaves the call. This is a system setting.
· Holding a Bridged Call
If a user puts a call they joined on hold, it is their connection to the joined call (conference) that is put on hold.
The other parties within the call remain connected and can continue talking. This will be reflected by the button
status indicators. The user who pressed hold will show 'on hold here' on the button they used to join the call. All
other appearance users will still show 'in use here'.
· Maximum Two Analog Trunks
Only a maximum of two analog trunks can be included in a conference call.
· Parked Calls
A Line Appearance button may indicate that a call is in progress on that line. Such calls to be unparked using a line
appearance.