User's Manual

Avaya Branch Gateway Manager 10.0 Page 428
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
· W - Withhold Outgoing CLI
Withhold the sending of calling ID number. Operation is service provider dependent.
· Y - Wait for Call Progress Message
Wait for a Call Progress or Call Proceeding message before sending any following digits as DTMF. For example, the
Y character would be necessary at a site where they have signed up with their telephone service provider to
withhold international dialing until a DTMF pin/account number is entered that initiates the call progress/
proceeding message.
· Z - Calling Party Name
This option can be used with trunks that support the sending of name information. The Z character should be
followed by the name enclosed in " " quotation marks. Note that their may be name length restrictions that vary
between line providers. The changing of name information on calls being forwarded or twinned may also not be
supported by the line provider.
· @ - Use Sub Address Field
Enter any following digits into the sub-address field.
· . - Dialed Digits
Replace with the full set of dialed digits that triggered the short code match.
· , - One Second Pause
Add a one second pause in DTMF dialing.
· ; - Receive Sending Complete
When used this must be the last character in the short code string. If the Dial Delay Count is 0, a ; instructs the
system to wait for the number to be fully dialed, using the Dial Delay Time or the user dialing #, to indicate
completion and then acting on the short code. If the Dial Delay Count is not zero, the dialing is only evaluated
when # is pressed.
· " " - Non Short Code Characters
Use to enclose any characters that should not be interpreted as possible short code special characters by the
system. For example characters being passed to the voicemail server.