User's Manual

Avaya Branch Gateway Manager 10.0 Page 386
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.19.2 IP Security Tunnel
5.19.2.1 Main
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Name: Default = Blank.
A unique name for the tunnel. Once the tunnel is created, the name can be selected as a destination for traffic in the IP
Route table.
· Local Configuration
The IP Address and IP Mask are used in conjunction with each other to configure and set the conditions for this
Security Association (SA) with regard to inbound and outbound IP packets.
· IP Address
The IP address or sub-net for the start of the tunnel.
· IP Mask
The IP mask for the above address.
· Tunnel Endpoint IP Address
The local IP address to be used to establish the SA to the remote peer. If left un-configured, the system will use the
IP address of the local interface on which the tunnel is to be configured.
· Remote Configuration
The IP Address and IP Mask are used in conjunction with each other to configure and set the conditions for this
Security Association (SA) with regard to inbound and outbound IP packets.
· IP Address
The IP address or sub-net for the end of the tunnel.
· IP Mask
The IP mask for the above address.
· Tunnel Endpoint IP Address
The IP address of the peer to which a SA must be established before the specified local and remote addresses can
be forwarded.
376