User's Manual

Avaya Branch Gateway Manager 10.0 Page 383
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Tunnel
5.19.1 L2TP Tunnel
5.19.1.1 Tunnel
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Name: Default = Blank.
A unique name for the tunnel. Once the tunnel is created, the name can be selected as a destination in the IP Route
table.
· Local Configuration
The account name and password is used to set the PPP authentication parameters.
· Local Account Name
The local user name used in outgoing authentication.
· Local Account Password/Confirm Password
The local user password. Used during authentication.
· Local IP Address
The source IP address to use when originating an L2TP tunnel. By default (un-configured), the system uses the IP
address of the interface on which the tunnel is to be established as the source address of tunnel.
· Remote Configuration
The account name and password is used to set the PPP authentication parameters.
· Remote Account Name
The remote user name that is expected for the authentication of the peer.
· Remote Account Password/Confirm Password
The password for the remote user. Used during authentication.
· Remote IP Address
The IP address of the remote L2TP peer or the local VPN line IP address or the WAN IP address.
· Minimum Call Time (Mins): Default = 60 minutes. Range = 1 to 999.
The minimum time that the tunnel will remain active.
· Forward Multicast Messages: Default = On
Allow the tunnel to carry multicast messages when enabled.
· Encrypted Password: Default = Off
When enabled, the CHAP protocol is used to authenticate the incoming peer.