User's Manual

Avaya Branch Gateway Manager 10.0 Page 360
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.13.4 Advanced
The settings on this tab are used for Frame Relay connections.
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Address Length
The address length used by the frame relay network. The network provider will indicate if lengths other than two bytes
are to be used.
· N391: Full Status Polling Counter
Polling cycles count used by the CPE and the network provider equipment when bidirectional procedures are in
operation. This is a count of the number of link integrity verification polls (T391) that are performed (that is Status
Inquiry messages) prior to a Full Status Inquiry message being issued.
· N392: Error Threshold Counter
Error counter used by both the CPE and network provider equipment. This value is incremented for every LMI error
that occurs on the given WAN interface. The DLCIs attached to the given WAN interface are disabled if the number of
LMI errors exceeds this value when N393 events have occurred. If the given WAN interface is in an error condition
then that error condition is cleared when N392 consecutive clear events occur.
· N393: Monitored Events Counter
Events counter measure used by both the CPE and network provider equipment. This counter is used to count the total
number of management events that have occurred in order to measure error thresholds and clearing thresholds.
· T391: Link Integrity Verification Polling Timer
The link integrity verification polling timer normally applies to the user equipment and to the network equipment when
bidirectional procedures are in operation. It is the time between transmissions of Status Inquiry messages.
· T392: Polling Verification Timer
The polling verification timer only applies to the user equipment when bidirectional procedures are in operation. It is
the timeout value within which to receive a Status Inquiry message from the network in response to transmitting a
Status message. If the timeout lapses an error is recorded (N392 incremented).