User's Manual

Avaya Branch Gateway Manager 10.0 Page 356
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.13.1 WAN Port
Use this form to configure the leased line connected to the WAN port on the Control Unit. Normally this connection is
automatically detected by the control unit. If a WAN Port is not displayed, connect the WAN cable, reboot the Control Unit
and receive the configuration. The WAN Port configuration form should now be added.
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Name
The physical ID of the Extension port,. This parameter is not configurable; it is allocated by the system.
· Speed
The operational speed of this port. For example for a 128K connection, enter 128000. This should be set to the actual
speed of the leased line as this value is used in the calculation of bandwidth utilization. If set incorrectly, additional
calls may be made to increase Bandwidth erroneously.
· Mode: Default = SyncPPP
Select the protocol required:
· SyncPPP
For a data link.
· SyncFrameRelay
For a link supporting Frame Relay.
· RAS Name
If the Mode is SyncPPP, selects the RAS service to associate with the port. If the Mode is SyncFrameRelay, the
RAS Name is set through the DLCIs tab.