User's Manual

Avaya Branch Gateway Manager 10.0 Page 355
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Incoming Call Route
5.13 WAN Port
These records are used to configure the operation of system WAN ports and services.
Creating a Virtual WAN Port
WAN services can be run over a T1 PRI trunk connection. This requires creation of a virtual WAN port. For full details
refer to Using a Dedicated T1/PRI ISP Link in Appendix A.
1.Select WAN Port.
2.Click and select PPP.
3.In the Name field, enter either LINEx.y where:
· LINE must be in uppercase.
· x is the line number. For a PRI/T1 module in Slot A, this will be 1. For a PRI/T1 module in Slot B, this will be
5.
· y is the lowest numbered channel number to be used by the WAN link minus 1. For example, if the lowest
channel to be used is channel 1 then y = 1 - 1 = 0.
4.In the Speed field, enter the total combined speed of the maximum number of channels sets in the Service.
· In this example, 12 channels x 64000 bits = 76800.Note: The maximum number of channels that can be used
will be limited by the number of data channels supported by the system Control Unit and not already in use.
5.In the RAS Name field, select the RAS name created when the new Service of that name was created.
6.Click OK.
788