User's Manual

Avaya Branch Gateway Manager 10.0 Page 337
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Service
5.10.1 Normal, WAN or Intranet Services
5.10.1.1 Service
Usability
· Mergeable: These settings are mergeable. Changes to these settings do not require a reboot of the system.
Configuration Settings
· Service Name
The name of the service. It is recommended that only alphanumeric characters be used.
· Account Name
The user name that is used to authenticate the connection. This is provided by the ISP or remote system.
· Password: Default = Blank
Enter the password that is used to authenticate the connection. This is provided by the ISP or remote system.
· Telephone Number: Default = Blank
If the connection is to be made via ISDN enter the telephone number to be dialed. This is provided by the ISP or
remote system.
· Firewall Profile: Default = Internet01 if present, otherwise <None>
From the list box select the Firewall Profile that is used to allow/disallow protocols through this Service.
· Encrypted Password: Default = Off
When enabled the password is authenticated via CHAP (this must also be supported at the remote end). If disabled,
PAP is used as the authentication method.
· Default Route: Default = Off
When enabled this Service is the default route for data packets unless a blank IP Route has been defined in the
system IP Routes . A green arrow appears to the left of the Service in the Configuration Tree. Only one Service can
be the default route. If disabled, a route must be created under IP Route.
· Incoming Password: Default = Blank
Shown on WAN and Intranet services. Enter the password that will be used to authenticate the connection from the
remote Control Unit. (If this field has appeared because you have created a Service and User of the same name, this is
the password you entered in the User's Password field).
375