User's Manual

Avaya Branch Gateway Manager 10.0 Page 336
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.10 Service
Services are used to configure the settings required when a user or device on the LAN needs to connect to a
off-switch data service such as the Internet or another network. Services can be used when making data
connections via trunk or WAN interfaces.
Once a service is created, it can be used as the destination for an IP Route record. One service can also be
set as the Default Service. That service will then be used for any data traffic received by the system for
which no IP Route is specified.
The system supports the following types of service:
· Normal Service
This type of service should be selected when for example, connecting to an ISP.
· WAN Service
This type of service is used when creating a WAN link. A User and RAS Service will also be created with the same
name. These three records are automatically linked and each open the same form. Note however, that this type of
Service cannot be used if the Encrypted Password option is checked. In this case the RAS Service name must
match the Account Name. Therefore either create each record manually or create an Intranet Service.
· Intranet Service
This type of service can be selected to automatically create a User with the same name at the same time. These
two records are linked and will each open the same form. The User's password is entered in the Incoming
Password field at the bottom on the Service tab. An Intranet Services shares the same configuration tabs as those
available to the WAN Service.